Jump to content
  • 0
Sign in to follow this  
ArrrrMatey

Deep click with 2 seperate actions

Question

I'm trying to get a regular or shallow click to send one key (9) and a deeper click to send (8)

I can only seem to get it to send either 9, or 98, but not just 8.

Is there a way to do this? I found a similar thread that seemed to indicate that 'stop further outputs' would do this, but it doesn't work for me. Here is my config now:

Capture.JPG.3f5846cba1121222f1b039e96ffdc6c6.JPG

Thanks!

Edited by ArrrrMatey
number reversed

Share this post


Link to post
Share on other sites

2 answers to this question

Recommended Posts

  • 0

Switching your output from press to release of the input should produce the desired outcome.

Share this post


Link to post
Share on other sites
  • 0

You must have the hands of a surgeon to pull this off :p

I'm so ham fisted that my normal settings for Deep Click is to have "do nothing on the initial press" with the normal use case output on the release phase. I then set the Deep Click between 70-90% and i have that run the special command only when i apply the required force and then have it block further outputs.

Tuudi had the correct answer to your question because you are going to trigger it on the release stroke not the input where it will trigger at the threshold for both 10 and 50 percent. My only question is do you really want the mouse button to do nothing bellow 10% pressure?

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×