Jump to content
Sign in to follow this  
Stinger6969

Tilt setup

Recommended Posts

@Stinger6969

The thread below has some detailed instructions for setting up a tilt command which should work for you. 

If you've already created a tilt mapping as described there, make sure your Z's tilt angles are calibrated. With the default mappings you will be able to do this by pulling the right trigger then leaving your Z flat on your desk for a few seconds. Otherwise you can run a full calibration via the Drivers main menu.

If you set you OLED to display tilt angles you can check that tilt has been calibrated with the 'R' value that is displayed. It should read 0.0 (or close to it) when your mouse is flat on your desk.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...